Dimplex REL5 Owner's Manual page 11

Fireplace Installation (continued)
5. Make sure all wires are secure
and do not protrude past the
flame panel, so as not to be
visible after final assembly.
6. Continue to the final assembly
instructions.
120V Installation - Wall
Switch
!
NOTE: Use a single pole, single
throw (On/Off) wall switch that is
rated for a minimum of
15 amps.
CAUTION: Use the appropriate
wire to meet local and national
electrical codes for rated power
consumption.
To wire through a wall switch:
1. Cut the wire to an appropriate
length.
Figure 6
WHITE - N
BLACK – L1
GROUND - G
www.dimplex.com
2. Connect the L wire from the unit
to the live wire from the main
power through the wall switch,
ensuring all live connections
are connected with a wire nut
(Figure 6).
3. Connect the N wire from the
unit to the neutral wire from the
power supply with a wire nut.
4. Connect the G wire from the
unit to the ground wire from the
power supply with a wire nut
or attach the grounding wire
to the cover with the provided
grounding screw, by placing the
wire in-between screw and lock
washer and tighten (Figure 4).
5. Make sure all wires are secure
and do not protrude past the
flame panel, so as not to be
visible after final assembly.
6. Continue to the final assembly
instructions.
WALL
SWITCH
WHITE – N
BLACK – L
GROUND - G
120 V
POWER
SUPPLY
(BREAKER
PANEL)
11