Landa EHW Series Operator's Manual page 37

Transmitter/Receiver Communication Set-up at Factory
Programming communication between the receiver and transmitter requires the removal of the receiver enclosure
lid. The receiver must have 120V power. This process utilizes the Function/Select buttons on the main panel control
board (PCB) of the receiver (See Figure below). A number of colored LED's are used to indicate various steps in the
programming process (See Figure below). It is recommended that this process is not done while wired to the
machine.
Transmitter
Button 1
Receiver Programming LED's and Programming Switches
The T60-04CRV receiver programming process is as follows: While programming, make sure there are no other
transmitters are transmitting in the area.
1. Press the Function button once to select the "Learn Code" mode. (#6 Red LED lights, you have approximately
5 seconds to make the next selection.)
2. Press the Select button once and then press any button on the transmitter and hold. (#6 Red LED will blink on/
off three times and go out. After releasing the transmitter button, the relays will respond to the appropriate buttons
(Button 1/R1; Button 2/R2; Button 3/R3; Button 4/R4); and the #6 red LED will blink on/off indicating that one or
more adjustable codes have been learned by this receiver.
3. Press and hold the Select button for 6-8 seconds so the yellow LED is on solid. (#7 Yellow LED lights)
NOTE: This step is only completed when establishing the first transmitter communication.
The receiver is now programmed to the desired transmitter.
#7 LED
#6 LED
Landa EHW Operator's Manual 8.941-114.0 - M
Handheld Wireless Operating Instructions
Receiver
Select
Button
Function
Button
37