Toshiba RAS-M10U2MUVG-E Service Manual page 66

No. Part name
1. Detachment
Fan motor
1) Remove the turbo fan, electric parts cover, wiring cover
and wiring fixing plate.
(Refer to
2) Remove the fan motor connector (CN210, White, 7P)
connected to the control P.C. board, and then take off
the lead wires from the clamp.
3) Remove the shoulder screws (Black, 2pcs.) of the
motor lead wiring cover, and separate the lead wires
and the lead wire cover.
4) Remove the hexagon nuts (M6) which fix the motor,
and the washers. (3 pcs. Each).
* When taking off them, hold them with a hand so that
5) Remove the motor with rubber cushion from the bolt.
2. Attachment
1) Pass rubber cushion of the motor in the bolt, put the
washer and the hexagon nut in this order, and then
tighten to fix them.
(Tightening toque: 4.9 ± 0.5N•m)
2) Pass the lead wire through the motor lead wire fixing
plate removed in 1-3), and then fix it with shoulder
screw.
3) Perform wiring of the motor lead wires as original,
connect the connector to the control P.C. board, and
then attach the wiring fixing plate and the wiring cover.
4) Following to works in
fan and the electric parts covers.
1. Detachment
TC
TCJ
1) Remove the drain pan. (Refer to
Sensor
2) Pull out the sensor to be exchanged from the sensor
holder.
3) Remove the connector connected to the control P.C.
board, and take off wires from the clamp. (Refer to
2. Attachment
1) Insert the sensor to be exchanged into the specified
sensor. (Refer to the right figure.)
2) Perform wiring of the sensor as original.
Procedure
-1, -1, -1-2,
motor will not fall down.
-2 and
-1-3.)
-2, attach the turbo
-1.)
.)
– 66 –
Remarks
Shoulder screws (Black)
Motor lead wire cover
TCJ sensor TCJ sensor TCJ sensor
(Red) (Red) (Red)
TC sensor (Black)
Bolt
Hexagon nut
Washer
Rubber
cushion