2. How to Cancel the Auto Restart Function
To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the signal and beeps three times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
• When the system is on stand-by (not operating)
Operation
Push [TEMPORARY] button for more than
three seconds. (Less than 10 seconds)
• When the system is operating
Operation
Push [TEMPORARY] button for more than
three seconds. (Less than 10 seconds)
3. Power Failure During Timer Operation
When the unit is turned off because of power failure during timer operation, the timer operation is cancelled. In
that case, set the timer operation again.
NOTE :
The Daily Timer is reset while a command signal can be received from the remote controller even if it stopped
due to a power failure.
The unit is on standby.
The unit starts to operate.
TEMPORARY
button
The unit beeps three times and continues to operate.
If the unit is not required to operate at this time, push [TEMPORARY]
button once more or use the remote controller to turn it off.
The unit is in operation.
The unit stops operating.
TEMPORARY
button
The unit beeps three times.
If the unit is required to operate at this time, push [TEMPORARY]
button once more or use the remote controller to turn it on.
Motions
↓
↓
After approx. three seconds, release
[TEMPORARY] button from being pushed.
Motions
↓
↓
After approx. three seconds, release
[TEMPORARY] button from being pushed.
– 43 –
The green indicator is on.
The green indicator is on.
The green indicator is turned off.