Remote Lock Replacement (Fiesta Hd) - Carefree FIESTA Service Manual

Carefree of Colorado
R L
EMOTE OCK
The Fiesta HD metal remote lock can be used as an upgrade to existing Spirit and Fiesta awnings. The kit
(901097HD) contains several sized rods that can be assembled to make the correct length of the remote lock.
1. Determine the correct length of the remote lock.
Bottom of
End Plug
Reference
Dimension
Top of
Travel Lock
1.1. Measure the distance from the top of the travel lock to the bottom of the end plug. This will be the
reference dimension for the chart below.
1.2. Remove the stirrup from the top of the base rod (A).
1.3. Based on the reference dimension, add the appropriate additional rods to the top of the base rod.
Reference Dimension
Rods to Use:
NOTE: The finished length of the rod does not match the reference dimension.
1.4. Thread stirrup onto rod.
2. Open the awning. On the left arm, raise and lock the upper brace in position. Do not
forget to tighten the black lock knob.
NOTE: As an additional safety, align the cotter pin holes in the LH cap and spring
and temporarily insert a lock pin through the hole. This will prevent the awning from
closing if the upper brace is not adequately tightened.
3. On the right side, tape the roller lock lever in the
CAUTION
close position while the end plug is not attached to the arm channel, the wound spring will
unwind quickly with significant force. Personal injury and/or property damage could occur.
4. (Detail A) Detach the end plug and lift off of the arm
channel. Unhook the old remote lock stirrup from the
lock lever while lifting the roller tube.
5. It will be necessary to hold onto the arm when the
end plug is removed.
6. It will be necessary to support or hold the roller tube
during the next two steps.
7. Slide the old remote lock out of the round groove of
the right arm.
8. Clean the groove then slide the new remote lock in.
Allow the lock to protrude over the arm channel.
9. Lift the roller tube over the arm channel and hook the remote lock stirrup over the lever. Slide the
remote lock into the channel while sliding the end plug onto the arm.
10. Align the holes and secure the end plug with the screw removed previously.
11. Remove cotter pin (if installed) and the tape used to hold the lock lever in place.
052876-301r5
R
EPLACEMENT
Slider
22.5"
A + D
The roller lock MUST stay in the open position. If the lever is pushed to the
Service Manual
(F HD)
IESTA
B (3")
31.5" 35.5"
A + C + D A + D + E
position.
OPEN
Roller Lock
Lever
M
ANUAL
D (11")
C (9")
A (Base)
38.5"
A + B +D + E
A
DETAIL DETAIL
Right Arm Assy Remote Lock
P A
ATIO WNINGS
E (13")
E (13")
Stirrup
SF025
48.75"
A + D + E + E
Spring
Lock Pin
SF026
Remote Lock
Round Groove
B
SF020
9