Advertisement
Spec Tech Industrial Electric
Chapter 1: Introduction & Overview
1.1: Face Panel Description
The Monitor's operating status is indicated by the two (2) LEDs on the face panel.
RUN
The green LED indicates that the card is operational.
FAULT
The red LED indicates there is a card fault, or when there is a resolver
(transducer) fault.
Note: There are four typical causes for a resolver (transducer) fault:
1. Broken resolver cable
2. Improperly wired cable
3. Faulty resolver
4. Non-compatible resolver
INSIDE FACE PANEL DOOR
Plug-in connector with 16 terminals. (See wiring diagrams, Appendix B)
Spec Tech Industrial Electric
www.spectechind.com
Installation & Programming Manual
www.spectechind.com
888-773-2832
2
888-773-2832
Advertisement
