Table of Contents
Advertisement
1.5 Rear Panel
IN Jack
This is the main input jack where your guitar plugs in.
SND 1-4, RTN 1-4 Jacks
–
–
These jacks provide mono-send mono-return effect loops. SND 1
4 send signals to effect pedals. RTN 1
4 receive
–
signals from effect pedals. Connect the SND 1
4 jacks to the INPUT jack of each effect pedal, and connect the
–
OUTPUT jack of each effect pedal to the RTN 1
4 jacks.
SND 5, RTN 5S Jacks
These jacks provide a mono-send stereo-return effect loop. RTN 5S jack is stereo capable using TRS connectors. If the
last stage of the chain is the stereo-send effect loop or the output, the signal is output in stereo. If the last effect loop
in the chain is the mono-send effect loop, only the signal received at the tip conductor of the RTN 5S jack is output.
SND 6S, RTN 6S Jacks
These jacks provide a stereo-send stereo-return effect loop. These jacks are stereo capable using TRS connectors. If the
last stage of the chain is the stereo-send effect loop or the output, the signal is output in stereo. If the last effect loop
in the chain is the mono-send effect loop, only the signal received at the tip conductor of the RTN 6S jack is output.
SND VL, RTN VL Jacks
These jacks are for connecting a volume pedal. You can also use these jacks as send/return for a preamp.
OUT L, OUT R Jacks
These are the output jacks. OUT-L and OUT-R can be turned on/off independently. If the last stage of the chain is the
mono output, the OUT-L signal is split up in to the OUT-R.
TUNER Jack
This jack is for connecting an external tuner.
F1/F2 Jack
Latch or momentary function switch jack for amplifier channel switching or on/off controlling of reverb.
TRS plug's Tip : F1
TRS plug's Ring : F2
TRS plug's Sleeve : Common ground for F1/F2
XPDL Jack
An expression pedals can be connected to this jack using a 1/4" TRS cable. Also an external Tap-Tempo switch and
LED to this jack using a 1/4" TRS cable. The TRS cable must be connected before supplying power to the EFX MK-V.
Refer to the 5.1 XPDL on the page 33 of the manual for cabling.
ISO OUT Jack and ISO PHASE Switch
There is an isolation transformer before the ISO OUT jack. The isolation transformer may help reduce hum that can
occur when using two amps or 4CM. If the ISO OUT are used, ISO OUT can also be inverted the phase by pressing
the ISO OUT PHASE switch. Refer to the ISO-OUT SOURCE on the page 29 of the manual.
MIDI IN, MIDI OUT/THRU Connector
MIDI IN connector receives MIDI signals from an external MIDI device. MIDI OUT/THRU connector is used to feed
MIDI signals to external MIDI devices. When the operation mode of MIDI OUT/THRU has been set to 'THRU', MIDI
signals received at MIDI IN pass through the EFX-LE without any changes.
DC12V Power Connector
This is the main power input for the EFX-LE. The EFX-LE requires a DC12V supply. The current draw is
approximately 250mA at DC12V (Center Negative).
6
EFX - LE Audio Controller Owner's Manual
Advertisement
Table of Contents
