Rear Panel - Musicom Lab MTX-5 Owner's Manual

PAGE
Pressing this switch puts the MTX-5 into the other page, where you can turn individual IA on and off, and store their
settings to presets.
Pressing & holding this switch for 1 second will store the IA edit and return to the page 1.
Factory setting provides 3 pages. Up to 8 pages can be used depending on the user's preference.
BANK UP and BANK DOWN
The 870 presets in the MTX-5 are arranged in banks of 3, and these switches allow you to select which bank of 3
you'd like to access. Pressing the P1 and P2 switches simultaneously executes the BANK DOWN function, and
pressing the P2 and P3 switches simultaneously executes the BANK UP function.
It is possible to activate/deactivate to move the BANK by pressing both switches at simultaneously Please refer to the
4.5.2 Other -> Sw 1-2-3 Bank on the page 23 of the manual.

1.5 Rear Panel

MIDI OUT1
MIDI OUT1 is a standard 5-pin MIDI connector used
to transmit MIDI signals to external MIDI devices.
The MTX-5 power can be supplied by phantom
power via pin 6 and 7.
MIDI OUT2 and MIDI OUT3
MIDI OUT2 and MIDI OUT3 are 1/8 inch phone connectors used to transmit MIDI signals to external MIDI devices.
MIDI OUT1, MIDI OUT and MIDI OUT3 allow MIDI to be transmitted without a separate MIDI splitter.
MIDI IN
MIDI IN connector receives MIDI signals from an external MIDI device.
The phantom power supplied from pin 6 and 7 of MIDI OUT1 can be supplied to the external MIDI device through
pins 6 and 7 of MIDI IN.
XPDL1 and XPDL2
An expression pedal or 2 external foot-switches(normally open type) can be connected to this jack using a 1/4" TRS
cable. The TRS cable must be connected before supplying power to the MTX-5. Refer to the 4 4 .5.1 MIDI -> XPDL on
the page 21 and 6 6 . Cables on the page 27 of the manual for cabling.
USB
This USB connector is used to connect this device to your PC or MAC to send and receive data or to update the
firmware. No driver installation is required because MTX-5's USB uses the HID class or USB Audio Device.
DC 9V
This is the main power input for the MTX-5. The MTX-5 requires an isolated DC9V power supply.
The current draw is approximately 100mA at DC9V (Center Negative).
MTX-5 MIDI Controller Owner's Manual 4