4. Installing in the interior Mounting Plate
Step 1.
Route the cable through the hole on Interior Assembly Mounting Plate.
Step 2.
Attach the Interior Assembly Mounting Plate on the door and tighten two Screws B.
If the thickness of the door is between 1-9/16'' to 2-3/8'' (40mm to 60mm), please use Screw B1.
If the thickness of the door is between 2-3/8'' to 3-1/8'' (60mm to 80mm), please use Screw B2.
If the thickness of the door is between 3-1/8'' to 4'' (80mm to 100mm), please use Screw B3.
Note:
1. The screw bolts of the Mounting Plate must face the installer.
2. Before tightening the screws completely, tighten one screw up to the middle, then, start with the second one,
this way you will have the right installation. After you have both screws up to the middle you can proceed and
tighten them completely.
5. Installing Interior Assembly
Step 1.
Adjust the handle direction of the Exterior Assembly. The operation is the same with the exterior handle.
Step 2.
After confirming the Extra Bolt is retracted, rotate the Extra Bolt Knob to Unlock. The knob and the cylinder
tailpiece should be all vertical.
- 9 -