Please watch our easy step by step installation video before attempting to install your Ultraloq UL3 Fingerprint and Touchscreen Smart Lock. www.u-tec.com/support If you have questions regarding the installation process Please contact us at customerservice@u-tec.com
Important Notes
Only use a power drill for making a hole. Do not use it for installation.
Install and test the lock with the door open to avoid being locked out.
Please read all the instructions before contacting customer support.
Please contact customer support before returning the product to the store.
DO NOT install the batteries before installing the lock! Follow the instructions in sequential order!
If you have previously installed this lock on another door, you must perform a Factory Default Reset FIRST! See the User Guide for more information.
This lock is designed for the following operating temperatures:
Outside Lock Body (exterior mounted): -31˚F (-35˚C) to 158˚F (70˚C)
Inside Lock Body (interior mounted): 14˚F (-10˚C) to 131˚F (55˚C)
Need Help? For technical documents and more Please visit www.u-tec.com/support Tel: 844-HEY-UTEC (844-439-8832) Email: customerservice@u-tec.com
Included in the box
Exterior Assembly
Interior Mounting Plate
Interior Assembly
Strike
Latch
Backup Keys
Spring
Screw A
Screw B
Screw C
Screw D
Screw E
Handle
Spindle
Drill
Screwdriver
AA Batteries
Preparing Door
Check the door's dimensions
Drill a hole in the door
Use the Drill Template provided in the box. If your door thickness is over 16.5"(42mm), Please install this spring.
Installing Latch and Strike
Install latch on the door. Make sure the latch angle faces door jamb.
Install the strike on the door frame, ensuring you allow for the bolt to be centered in the strike.
Before installing the lock on the door
Loosen the screw holding the battery cover.
Slide the battery cover up and out (note the two tabs at the bottom of the battery cover).
Remove the inside mounting plate (with gasket) from the back (door side) of the interior assembly.
Installing Exterior Assembly
Install the exterior assembly. Route the cable under bolt and through hole stated below.
Installing Interior Mounting Plate
Install interior mounting plate. Secure it to the exterior assembly using screws.
Plug in the spindle.
Installing Interior Assembly
Attach the cable to the interior assembly printed circuit board (PCB) by lining up notches on the cable connector to slots on the PCB connector. Press the connector in firmly using thumbs until completely seated.
Secure interior assembly using screws.
Installing Batteries
Insert 3 AA alkaline batteries.
Install battery cover and tighten the screw.
Installing Handles
Press lever handles onto handle posts.
Test the mechanical operation of the lock by rotating handle from inside. The movement of the bolt should be smooth and unobstructed. If the operation is not smooth, review the previous steps to ensure proper installation.
If the handles are installed in the wrong direction, you need to remove them and re-install. To remove the handle, you need to insert the screwdriver into the hole in the handle, push in and hold. Then pull the lever handle out.
Congratulations! You have installed the Ultraloq UL3 Fingerprint and Touchscreen Smart Lock successfully.
Need Assistance?
Do you have a question about the Ultraloq UL3 that isn't answered in the manual? Leave your question here.