U-tec Ultraloq UL3 Installation Instructions Manual
Fingerprint and touchscreen smart lock
Hide thumbs
Also See for Ultraloq UL3:
- User manual ,
- Installation instructions manual (33 pages) ,
- Installation instructions manual (12 pages)
Related Manuals for U-tec Ultraloq UL3
Summary of Contents for U-tec Ultraloq UL3
- Page 1 Ultraloq UL3 Fingerprint and Touchscreen Smart Lock Installation Instructions ( V1.3 ) Welcome...
- Page 2 Installation Video Please watch our easy step by step installation video before attempting to install your Ultraloq UL3 Fingerprint and Touchscreen Smart Lock. www.u-tec.com/support If you have questions regarding the installation process Please contact us at customerservice@u-tec.com Important Notes • Only use a power drill for making a hole.
- Page 3 Included in the box Exterior Interior Interior Assembly Mounting Plate Assembly Strike Latch Backup Keys Spring Screw A Screw B Screw C Screw D Screw E Spindle Drill Screwdriver Handle AA Batteries - 2 -...
- Page 4 Preparing Door Check the door’s dimensions ” 1 ” (35 mm-44mm) Door Edge ” (70 mm) ” (60 mm) ” (53 mm) Hole 1” (25 mm) Drill a hole in the door Use the Drill Template provided in the box. - 3 -...
- Page 5 Preparing Door If your door thickness is over 16.5”(42mm), Please install this spring. Interior Spring ×1 - 4 -...
- Page 6 Installing Latch and Strike 1. Install latch on the door. Make sure the latch angle faces door jamb. 2. Install the strike on the door frame, ensuring you allow for the bolt to be centered in the strike. Angle faces jamb Adjust the latch basket length Screw A...
- Page 7 Installing Exterior Assembly 1. Install the exterior assembly. Route the cable under bolt and through hole stated below. - 6 -...
- Page 8 Installing Interior Mounting Plate 1. Install interior mounting plate. Secure it to the exterior assembly using screws. 2. Plug in the spindle. Screw B Route wire over the hole Plug in the spindle - 7 -...
- Page 9 Installing Interior Assembly 1. Attach the cable to the interior assembly printed circuit board (PCB) by lining up notches on the cable connector to slots on the PCB connector. Press the connector in firmly using thumbs until completely seated. 2. Secure interior assembly using screws. Screw C Screw D Connect the cable...
- Page 10 Installing Batteries 1. Insert 3 AA alkaline batteries. 2. Install battery cover and tighten the screw. Screw E - 9 -...
- Page 11 To remove the handle, you need to insert the screwdriver into the hole in the handle, push in and hold. Then pull the lever handle out. Congratulations! You have installed the Ultraloq UL3 Fingerprint and Touchscreen Smart Lock successfully. - 10 -...
- Page 12 Handle plug position The handle is plugged in correctly. The handle is not fully plugged in. - 11 -...
- Page 13 Note Date...
- Page 14 Note Date...
- Page 15 Note Date...
- Page 16 U-tec and Ultraloq brands and products are trademarked and protected under law in the United States. Unauthorized use is prohibited. Ultraloq is sub-brand of U-tec Group Inc. 2016 © U-tec Group Inc. All Rights Reserved.