All manuals and user guides at all-guides.com Installation Video Please watch our easy step by step installation video before attempting to install your Ultraloq UL3 Fingerprint and Touchscreen Smart Lock. www.u-tec.com/support If you have questions regarding the installation process Please contact us at customerservice@u-tec.com Important Notes •...
All manuals and user guides at all-guides.com Included in the box Exterior Interior Interior Assembly Mounting Plate Assembly Strike Latch Backup Keys Spring Screw A Screw B Screw C Screw D Screw E Spindle Drill Screwdriver Handle AA Batteries - 2 -...
Page 4
All manuals and user guides at all-guides.com Preparing Door Check the door’s dimensions ” 1 ” (35 mm-44mm) Door Edge ” (70 mm) ” (60 mm) ” (53 mm) Hole 1” (25 mm) Drill a hole in the door Use the Drill Template provided in the box.
Page 5
All manuals and user guides at all-guides.com Preparing Door If your door thickness is over 16.5”(42mm), Please install this spring. Interior Spring ×1 - 4 -...
Page 6
All manuals and user guides at all-guides.com Installing Latch and Strike 1. Install latch on the door. Make sure the latch angle faces door jamb. 2. Install the strike on the door frame, ensuring you allow for the bolt to be centered in the strike. Angle faces jamb Adjust the latch basket length...
All manuals and user guides at all-guides.com Installing Exterior Assembly 1. Install the exterior assembly. Route the cable under bolt and through hole stated below. - 6 -...
Page 8
All manuals and user guides at all-guides.com Installing Interior Mounting Plate 1. Install interior mounting plate. Secure it to the exterior assembly using screws. 2. Plug in the spindle. Screw B Route wire over the hole Plug in the spindle - 7 -...
All manuals and user guides at all-guides.com Installing Interior Assembly 1. Attach the cable to the interior assembly printed circuit board (PCB) by lining up notches on the cable connector to slots on the PCB connector. Press the connector in firmly using thumbs until completely seated.
All manuals and user guides at all-guides.com Installing Batteries 1. Insert 3 AA alkaline batteries. 2. Install battery cover and tighten the screw. Screw E - 9 -...
To remove the handle, you need to insert the screwdriver into the hole in the handle, push in and hold. Then pull the lever handle out. Congratulations! You have installed the Ultraloq UL3 Fingerprint and Touchscreen Smart Lock successfully. - 10 -...
Page 12
All manuals and user guides at all-guides.com Handle plug position The handle is plugged in correctly. The handle is not fully plugged in. - 11 -...
Page 13
All manuals and user guides at all-guides.com Note Date...
Page 14
All manuals and user guides at all-guides.com Note Date...
Page 15
All manuals and user guides at all-guides.com Note Date...