Touchscreen Smart Lock. www.u-tec.com/support If you have any questions regarding the installation process please contact us at customerservice@u-tec.com Important Notes • DO NOT use a power drill for installation! • Install and test lock with door open to avoid being locked out.
Included in the box Exterior Interior Interior Assembly Mounting Plate Assembly Strike Latch Backup Keys Strike Plate Screws Screws Screws Spindle Drill Screwdriver Handle AA Batteries - 2 -...
Page 4
Preparing Door Check door dimensions Door Edge ” (70 mm) ” (60 mm) ” (53 mm) Hole 1” (25 mm) Drill a hole on the door Use Drill Template provided in the box. - 3 -...
Page 5
Installing Latch and Strike 1. Install latch in door. Make sure latch angle faces door jamb. 2. Install strike on the door frame, making sure to allow for the bolt to be centered in the strike. Angle faces jamb Adjust the latch basket length Strike Screws Strike Screws...
Page 6
Installing Exterior Assembly and Interior Mounting Plate 1. Install the exterior assembly. Route cable under bolt and through hole indicated below. 2. Install interior mounting plate. Secure it with exterior assembly using screws. 3. Plug in spindle. Plate Screws Route wire over the hole Plug in the spindle - 5 -...
Installing Interior Assembly 1. Attach cable to the interior assembly printed circuit board (PCB) by lining up notches on cable connector to slots on PCB connector. Press connector in firmly using thumbs until completely seated. 2. Secure interior assembly using screws. Set Screws Connect the cable - 6 -...
Installing Handles 1. Press lever handles onto handle posts. 2. Test the mechanical operation of the lock by rotating handle from inside. The movement of the bolt should be smooth and unobstructed. If operation is not smooth, review the previous steps to ensure proper installation. If the handles are installed in wrong direction, you need to remove them and re-install.