Flood Float And Switch; Air Gap - GE CDT865SxJ0 Series Technical Service Manual

Flood Float and Switch

The Flood Float is located in the sump. The Flood
Switch is located on the underside of the sump. It
Flood Switch Removal
If the dishwasher is installed with the level legs
extended, the 1/4 in. hex head screw may be
removed without removing the sump.
1. Remove power to the dishwasher.
2. Remove the toe kick.
3.
applicable). See the Floor Protection Pan
section of this service guide.
4.
removal without removing the sump (see Sump
Module Removal section of this service guide, if
needed).
5.
removing the 1/4 in. hex head screw.

Air Gap

The air gap allows air to enter into the tub during
the dry portion of the cycle. It is located on the left
side of the dishwasher tub, and must be removed
from the installation to access. Remove by turning
the mounting nut counterclockwise from the inside
of the tub.
Sump
The air gap may now be removed from the outside
of the tub. There is a gasket between the air gap
Flood
and the tub.
Switch
Mounting
Screw
– 61 –