Table of Contents
Advertisement
Vent Parts
Mounting Screw
Vent Duct and Fan
Gasket
Vent Cover
Power Dry Models
Power Dry Models have a 13.5 VDC fan and
ducting to the bottom of the door. The Power
Dry system must be removed to access the door
diagnoses will be covered in the Dry System section
of this service guide.
Power Dry System Removal
1. Remove the inner door vent cover.
2. Disconnect the wire harness from the fan to the
UI control.
3. Remove the 1/4 in. hex head screw.
If alignment causes a binding on the tab, it can be
removed, the purpose for the tab is to aid assembly
in the factory. The vent cover provides the main
attachment for the venting assembly.
4. The vent conduit, fan and the duct are removed
as an assembly.
Conduit
Fan (Inside Duct)
Duct
NOTE: Vent fan and diagnostics may be found in the
Dry System section of this service guide.
Page 37
- Quick Links:
- Troubleshooting
- Consumer Error Mode
- Service Mode
Hide quick links:
Advertisement
Table of Contents
