Conformity; Safety Instructions For Press Brakes - Amada Promecam ITS 50/12 Technical Manual

PROMECAM
2 - SAFETY
2 . . 1 - CONFORMITY
Press brakes are shipped from the factory with basic safety equipment including:
A double foot pedal (close/open).
A switch-operated mode selector.
Lateral protection
Back protection
SeH-supervising electrical and hydraulic circuits
Optional: equipment for a second operator.
2.2 - SAFETY INSTRUCTIONS FOR PRESS BRAKES
Do not use, adjust or undertake any action on the machine without first having read the instructions.
Observe all safety instructions when using this press.
Do not place hands between tools.
Do not place hands between tools to adjust the back gauge.
Do not operate press if side or rear safety panels are not in place.
Do not remain between the protective pieces and the danger area.
Before any operation make sure that :
- all
protective devices are in place
- the operating cycle is correct for the work to be done
- nothing is interfering in-between the tools
- there is open access to the various parts of the machine
- the floor around the machine is free of grease, oil or water.
Make sure that gloves are worn during operation
'TS/ITPS -
SAFETY
2-1/4