Operation - Amada Promecam ITS 50/12 Technical Manual

&MADA
PROMECAM
15 - 2 OPERATION
15 - 2 - 1
MANUAL MODE
- Press the
D
key (30) to go into manual mode.
roAI
- Select the mm or inch unit by holding down
w.J
(13) for 2 seconds.
- By pressing the
D D
a
(1, 2 or 3) keys, the alphanumeric display (24)
shows the entry MANUAL X, MANUAL Y or A
=
nn.n.
a) MANUAL X:
- Pressing the
Q
key (7) makes the X axis move away from the bending axis.
- Pressing the
D
key (8) makes the X axis move closer to the bending axis.
b) MANUAL Y:
- Pressing the
Q
key (7) makes the distance between the punches and dies increase
(pedal up, engaged).
- Pressing the
D
key (8) makes the distance between the punches and dies decrease
(pedal up, engaged).
A short impulse on (7) or (8) results in a movement of 0.01 mm.
NOTE:
Simultaneous pressing of (7) or (8) and (6) results in high-speed rotation of the motor of the
axes In question (X or V).
15-2/14
TECHNICAL MANUAL -
Issue:
4/90