Use Without Numerical Control; Preliminary Operations; Important Recommendations; Turning On And Off - Amada Promecam ITS 50/12 Technical Manual

PROMECAM
14 - USE WITHOUT NUMERICAL CONTROL
14 - 1 PRELIMINARY OPERATIONS
Before carrying out any bending operations, it is necessary to define:
The bending technique:
- air bending
or
- coining (see section 13)
14 - 2 IMPORTANT RECOMMENDATIONS
In order to avoid any accident during bending operations, it is imperative that the instructions
below be followed:
a. Never run the pump when there is no oil in the tank.
b. Never use the pressure regulator on the bending depth setting.
C.
Do not exceed the maximum permissible force for tools.
d. After usage, completely loosen the pressure regulator and the hydraulic gauge control.
14 - 3 TURNING ON AND OFF
See section 11.2.
14 - 4 MUTE LEVEL SETTING (SEE SECTION 13.4.6)
I.T.S - USE WITHOUT NUMERICAL CONTROL
14 - 1/4