Pressure Regulator Setting - Amada Promecam ITS 50/12 Technical Manual

tlMADA
PROMECAM
14 - 5 PRESSURE REGULATOR SETTING
The regulator control makes it possible to set the required force.
This operation is carried out by actuating the regulator control.
The force is checked on the pressure gauge.
The pressure gauge has two graduated scales, continuously giving the following information:
The force in tonnes, given by the small side of the needle, on the black scale,
The minimum bending length in order to not damage the tool, given by the large side of
the needle, on the red scale.
CAUTION
NEVER USE THIS CONTROL TO SET THE AIR BENDING DEPTH (NO ACCURACY
SETTING FOR END-OF-BENDING DIIVIENSION)
Adjusting Force as a Function of Bending Length
This setting consists in limiting the force of the press in relation to the permissible unit load of
1.2 tons per centimetre of bending length.
This setting must be made before carrying out any bending operation (no matter what technique is
used), with a view to preventing any deterioration of bending tools or of their supporting forces.
14 - 2/4
INSTALLATION MANUAL - Issue: 4190