Amada Promecam ITS 50/12 Technical Manual page 68

ilMADA
PROMECAM
15 - 2 - 2
PROGRAMMING
- Go into programming mode by pressing
I·€> I
(29). All the display windows are empty,
except for 19 (bend number) and 20 (program number set to 1).
- The indicator lights (27) light up in accordance with the last selection made (inches or
millimeters) .
- Select the program number (from 1 to 9) then press key
c::::J
(9).
The amount of available memory is displayed (maximum of 81 steps). The program number
selected is displayed on (20). The number of the first non-programmed bend ;s displayed on (19).
1 -
ENTERING X-AXIS VALUE
- Enter the dimension on the numeric key-pad (26).
- Press
0
key (1); the value appears on the display (18).
2 -
ENTERING V-AXIS VALUE
- Enter the dimension on the numeric key-pad (26).
- Press
c=:J
key (2); the value appears on the display (17).
- A sound signal indicates and confirms that it has been stored in memory.
3 -
ENTERING AUX-AXIS VALUE
- Enter the dimension on the numeric key-pad (26).
- Press
6
key (3); the value appears on the display (24).
4 -
RELEASE OF PART
_ Between two successive bends, it may prove necessary to provide a withdrawal on the X axis,
or simply a waiting time for this axis, before positioning a new part. -,,'
_ After a bend has been made, the rear gauge assembly is locked for a time that can be
programmed from
0
to
9
seconds.
- Program this time on numeric key-pad (26).
- Press
~
key (4).
- The withdrawal time is then entered in memory.
_ Programming of a withdrawal time validates this value on the selected bend(s).
_ To cancel the withdrawal time programming, simultaneously press the
andthe
~
key (4).
o
key (25)
15-4/14
TECHNICAL MANUAL - Issue: 4/90