Amada Promecam ITS 50/12 Technical Manual page 64

PROMECAM
After making the final setting, tighten the locking screw to lock the assembly in place.
NOTE 1: If too closed of a bend is obtained during settings, release the control pedal and
turn the hydraulic gauge block control In the clockwise direction.
NOTE 2: In the case of blow bending, if the bend is too closed, turn the hydraulic gauge
assembly control in the clockwise direction. In this case a bend that Is more
closed than the angle of the tool Indicates that the force is too low.
NOTE 3: If there are several variations in angles over the entire length of the bend, check
that the tools (the die and the punch) are in good condition. Adjust the
Intermediate sets.
14 - 4/4
INSTALLATION MANUAL - Issue:
4/90