Start-Up; Description Of Cycles - Amada Promecam ITS 50/12 Technical Manual

PROMECAM
11 - 2 START-UP
- Turn master switch (D); the white indicator light (E) lights up.
- Turn motor starting key (F); the green indicator light (G) lights up.
If the machine has numerical control:
- Put switch (K) on numerical control position.
- The numerical control lights up and makes a sound modulation.
- The numerical control is then ready to bH reset.
11 - 3 DESCRIPTION OF CYCLES
THE OPENING PEDAL OVERRIDES IN ALL CASES.
Above the mute level, the opening pedal must be held down in order to open.
Below the mute level, the opening pedal must be released. In this case, the press is open to
B.D.C. as set. J '
CYCLE 1 : adjustment
- Means of control: pedal
- Cycle selector (H) on position 1
- On all travel: working (operating) speed
- Stoppage at mute level if the selection was made on selector (I)
~"'4 2.c~
3
. - - STOP
<,,"""
CYCLE 2:
- Means of control: pedal
- Cycle selector
(H)
on position 2
BREAKDOWN OF CYCLE
- Closure at approach speed up to mute level.
- Mayor may not stop at sequence level (selection made by switch (I)).
- Closure at working speed.
- Automatic pressure holding or pressure holding by pedal, according to selection made on
selector (L).
- Automatic decompression.'
- Opening at high-speed down B.D.C. as set.
RELEASE OF THE PEDAL DURING THE CLOSURE PHASE CAUSES THE BEAM TO STOP IN
WHATEVER POSITION IT IS FOUND.
11-2/12
TECHNICAL MANUAL - Issue:
4/90