Amada Promecam ITS 50/12 Technical Manual page 17

PROMECAM
5 - INSTALLATION
5.1 -INSTRUCTIONS PRIOR TO HANDLING AND INSTALLATION
5.1.1 -
PREPARATION OF THE INSTALLATION FLOOR
Once the location is prepared, carefully sweep the area to be occupied by the press.
5.1.2 -
FORBIDDEN OPERATIONS
In no case should handling accessories (slings, hooks, straps, etc.) be attached to the following
components:
- Upper beam
- Lower beam
- Electrical cabinet
- NC Cabinet
- Bending Depth control
(ITS)
- Pressure limiter
(ITS)
- Mechanical protectors on:
- Goose neck
- back of machine
- Hooding
- Back gauge
Please see section 5.3.2 to identify the areas recommended for floor support.
IMPORTANT
CERTAIN PARTS OF THE MACHINE (ESPECIALLY ITS NUMERICAL CONTROL IF
FITTED) ARE NOT DESIGNED TO WITHSTAND THE WEIGHT OF A MAN WITHOUT
DEFORMATION. THEY ARE INDICATED BY A TAG AS ILLUSTRADED ON FIG. 5.1
Figure
5.1
ITS/ITPS -INSTALLATION
5-1/4