Cleaning, Care And Maintenance; Troubleshooting - STIEBEL ELTRON DHF 13 C Operating And Installation

OPERATION

Cleaning, care and maintenance

Following an interruption of the water supply
Material losses
!
Following an interruption of the water supply, the
appliance must be recommissioned by carrying out the
following steps:
f Disconnect the appliance from the power supply by f
removing the fuses/tripping the MCBs.
f Open the tap for one minute until the appliance and f
its upstream cold water inlet line are free of air.
f Switch the mains power back ON again. f
5. Cleaning, care and maintenance
f Never use abrasive or corrosive cleaning agents. A damp f
cloth is sufficient for cleaning the appliance.
f Check the taps regularly. Limescale deposits at the spouts f
can be removed using commercially available descaling
agents.
6.

Troubleshooting

Problem Cause
The appliance will not There is no power.
start despite the DHW
valve being fully open.
The flow rate is too low
for the appliance to start
heating at the selected
output. The aerator in
the tap or the shower
head is scaled up or con-
taminated.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-00000):
www.stiebel-eltron.com
Remedy
Check the fuses/MCBs in
your fuse box/distribu-
tion panel.
Clean and/or descale the
aerator or shower head.
Nr.: 000000-0000-00000
DHF-C | 21