Driver Information Set Command - Toshiba B-SX600 Series Command Manual

19. DRIVER INFORMATION SET COMMAND

Format
Byte/bit 7 6
0
Header
1
2
Command identifier
3
4
Data size (n)
5
6
Data type
7
8
to Data (n bytes)
n+7
Function
This command is issued by the printer driver to notify the language monitor of the printer driver information
including the window handle.
Explanation
• This command is used only between the printer driver and the language monitor, and not sent to the
port monitor.
• To meet the future increase of the data volume, the data size and data type are provided.
Data Data
size size
0 4 The upper word is 0.
The lower word is the window handle of the
printer driver (or application program)
1 2 Model (installed option) ID
2 24 Timeout value (msec.)
4 byte each x 6
1. ReadIntervalTimeout
2. ReadTotalTimeoutMultiplier
3. ReadTotalTimeoutConstant
4. WriteTotalTimeoutMultiplier
5. WriteTotalTimeoutContant
6. WriteTimeOut
5 4 3 2
Data
1 0
'/'
'T'
'D'
'I'
The language monitor checks this command for
every document.
issued, the language monitor sends a response via
the ReadPort, not via the status monitor.
0: Standard (B-SX600-HS11/HS12-QM-R)
1: Peel-off (B-SX600-HH11/HH12-QM-R)
2: Cutter (B-SX600-HC11/HC12-QM-R)
If the port monitor does not respond to this
command
language monitor stops obtaining the status and
proceeds to the next task.
- 31 -
B-SX600 Command Manual
Remarks
When this command is not
within the specified timeout, the