Table of Contents
Advertisement
5-ADVANCED CONFIGURATIONS: PROCEDURE FOR THE REPLACEMENT OF A SENSOR
Find below the procedure to follow
for the replacement of a sensor of
your MyBoat KIT:
1. Check that the type of sensor to
replace (S1, S2, S3, S4 ... S8)
has the same code of the model
replacing it;
Check the ID label on the back of the configura-
tion button
2. Remove the battery from the old
sensor to stop it communicating
with the control unit;
3. Via the app, from the "SET-
TINGS" -> "ONBOARD SYSTEM"
menu, select "CHANGE SEN-
SORS" (this will enable the lis-
tening mode of the control unit
to proceed to the registration of
the new sensor);
4. On the MyBoat control unit dis-
play, select the radio menu with
the SCR key (top RH corner,
further info on page 8)
30
5. Keeping the SCR key pressed,
the activation menu will be
displayed. Scroll the menu to
the sensor to replace and select
"CHANGE LH" with the LH key.
6. Insert the battery into the new
sensor (see page 9) and press
the red button of the sensor
(figure 1 on the side) for a few
seconds;
7. The control unit display
will show the "OK SENSOR
CHANGED" message;
8. At this point the procedure is
complete. The configuration
menu displayed will close auto-
matically;
USER MANUAL MI004913-E
configuration button
Figure 1
9. To check the operation has been
successful, just press the red
button again. The control unit
display will show the sensor
status.
Advertisement
Table of Contents
