Table of Contents
Advertisement
2 - INSTALLATION: SENSOR INSTALLATION
S2 and S6 Bilge 1 and 2 control
alarm disabled
alarm enabled
Figure 1
Empty bilge
Figure 2
Full bilge
sensor
cable in black sheath
cable supplied
USER MANUAL MI004913-E
1. Remove the protection tab to
power the sensor;
2. Identify the installation points
of the sensor and level contact,
pulling the cable supplied (as
in Figure 1) and clean the two
areas identified;
3. Remove the velcro protection
film from both the sensor and
the contact and apply in the two
areas identified, pressing lightly
for a few seconds.
N.B.: Ensure that, once applied,
the level contact does NOT touch
the water in the bilge;
level
contact
11
Advertisement
Table of Contents
