Table of Contents
Advertisement
2 - INSTALLATION: SENSOR INSTALLATION
S7 and S8 Hatch 1 and 2 control
alarm disabled
alarm enabled
14
Sensor S7/S8
OPEN
Magnet 2
Installation detail
USER MANUAL MI004913-E
1. Remove the protection tab to
2. Identify the installation point of
Closed hatch
3. Apply the round velcro patch onto
4. Check it is positioned correctly
5. Remove the velcro protection film
Open hatch
Magnet
If it is not possible to position the
magnet and sensor on axis, use the
type 2 magnet as shown in the figure.
Sensor S2
power the sensor;
both the sensor (e.g. door frame,
lintel) and the magnet (assess
whether to use a type 1 or type
2 magnet, according to require-
ments) and clean the 2 areas
identified;
the magnet;
and, to guarantee it works prop-
erly, leave a maximum distance
of 10 mm between the two ele-
ments;
from both the sensor and the
magnet, apply in the two areas
identified, pressing lightly for a
few seconds.
Advertisement
Table of Contents
