Installation: Installation Of The Myboat Control Unit - Seneca MyBoat User Manual

Hide thumbs Also See for MyBoat:
Table of Contents

Advertisement

2 - INSTALLATION: INSTALLATION OF THE MYBOAT CONTROL UNIT

N.B.:
For optimum reception of the GPS
signal given by satellites, it is better
to place the MyBoat horizontally on
a surface in an area not covered
by metal structures. If this is not
possible, an optional external anten-
na with 3m cable (code A-GPS) is
available.
First startup procedure:
1. Insert the mini SIM card into the
switched-off MyBoat control unit
(*);
2. Insert the SD card (see figure 2);
3. Connect the GSM/GPRS antenna
(**);
4. Connect the power supply to
the terminal block following the
instructions on page 29;
5. Insert the cigarette lighter plug
to switch the MyBoat control
unit on.
To confirm the first startup procedure
is correct, the GSM LED will start
flashing 3 times a second.
Switching on and scroll keys:
MyBoat is fitted with an ON/OFF
PWR key positioned in the LH top
corner (Figure 3).
08
To switch it off, keep the PWR key
pressed for a few seconds.
The device is fitted with a SCR key,
in the RH top corner. Pressing this
key displays the parameters.
FW update procedure:
The update of the control unit firm-
ware is possible via the micro SD
card supplied. Follow the following
procedure:
1. Copy the file FW.BIN in the main
folder of the micro SD card;
2. Switch the control unit on (***).
3. Insert the micro SD card into
the MyBoat control unit;
4. Wait for the message confirming
the update of the firmware;
5. Press "OK" and wait for instal-
lation to complete with the unit
restarting;
6. The control unit writes the new
firmware on the flash memory
during this phase.
N.B. In order to guarantee the
MyBoat control unit works correct-
ly, THE CONTENT OF THE SD CARD
MUST NOT BE REMOVED.
USER MANUAL MI004913-E
Figure 2
Figure 3
(*) Ensure you have removed the locking PIN during
the switch-on phase using another device, and at the
same time check data connection is working properly.
(**) Connect any A-GPS optional antenna following the
procedure supplied with the antenna.
(***) Ensure the control unit is powered via the ciga-
rette lighter cable supplied.

Advertisement

Table of Contents
loading

Table of Contents