1. Manuals
  2. Brands
  3. Seneca Manuals
  4. Remote Control
  5. MyBoat
  6. Installation manual

Seneca MyBoat Installation Manual

Real time remote control and alarm management device for boats
Hide thumbs Also See for MyBoat:
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION MANUAL
MyBoat
Real time remote control and alarm management
device for boats
EN
SENECA s.r.l.
Via Austria, 26 – 35127 – PADOVA – ITALY
Tel. +39.049.8705355 - 8705359 - Fax +39.049.8706287
For manuals in other languages and the configuration software, visit www.seneca.it/myboat
MI00498-2-EN
1/8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MyBoat and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Seneca MyBoat

Summary of Contents for Seneca MyBoat

  • Page 1 Real time remote control and alarm management device for boats SENECA s.r.l. Via Austria, 26 – 35127 – PADOVA – ITALY Tel. +39.049.8705355 - 8705359 - Fax +39.049.8706287 For manuals in other languages and the configuration software, visit www.seneca.it/myboat MI00498-2-EN...

  • Page 2: Module Layout

    WARNING: The full content of this manual must be read before any operation. The module must only be used by qualified electricians. Specific documentation is available at www.seneca.it/myboat The module must be repaired and damaged parts replaced by the Manufacturer. The product is sensitive to electrostatic discharges.

  • Page 3: Technical Specifications

    Quad band (850 / 900 / 1800 / 1900 MHz) MMCX CONNECTOR External GPS antenna connector (optional) ENVIRONMENTAL CONDITIONS Seneca recommends use at 0 to 45 ° C for correct operation. Temperature With the power supply present: -20 .. +55°C With use of the battery (when discharged): -20 ..

  • Page 4: Inserting The Sim Card And Sd Card

    INITIAL POWERING ON OF THE DEVICE MyBoat is supplied in “shipping mode”. This mode prevents any unnecessary discharge of the battery during transport as well as any accidental switch-ons. When switched on for the first time, power the device with the power cord supplied; this allows "shipping mode"...

  • Page 5: Safety Information

    ASSEMBLY REGULATIONS For optimal reception of the GPS signal given by the satellites, MyBoat should be positioned in an area not covered by metal structures. If this is not possible or if the satellite reception is no good, an optional external antenna with 3m cable (code A-GPS) is available.

  • Page 6: Electrical Connections

    ELECTRICAL CONNECTIONS INSERTION AND EXTRACTION FROM TERMINALS WITH A PUSH-WIRE CONNECTION Insertion of a rigid cable Insertion of a thin cable Extraction of a rigid cable A: press with a A: press with a screwdriver screwdriver Press down Recommended flaying: B: insert B: extract 8-9 mm...
  • Page 7 BATTERY REPLACEMENT Use a Phillips screwdriver and remove the screws (reference 1 and 2). Open the top cover, remove the battery and insert a new CR2 battery, with the correct polarity (see following image). Replace the cover and tighten the screws firmly all the way. Do not overtighten the screws to avoid breaking the cover.

  • Page 8: Contact Information

    Product information sales@seneca.it This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised. The content of this document corresponds to the described products and technologies. Stated data may be modified or supplemented for technical and/or sales purposes.

Table of Contents