2 - INSTALLATION: REPLACING THE SENSOR BATTERY
screw 1
Figure 1
Figure 2
screw 2
All sensors are factory-set and sup-
plied with a battery.
To replace the batteries in the
sensors, follow the following instruc-
tions:
•
With a cross head screwdriv-
er, remove the two fastening
screws from the dome as shown
in Figure 1;
•
Open the dome paying attention
to the orientation as in Figure 2;
•
Insert the battery supplied with
the positive pole as shown in
Figures 3 and 4;
•
Close the sensor dome again
and fasten the screws.
USER MANUAL MI004913-E
Figure 3
Figure 4
09