•
The falling danger of the tractor can be
reduced by winching through the lower
snatchblock.
JL 351P
PRE-OPERATION CHECKS
MOUNTING AND USE OF THE LOWER
SNATCHBLOCK
•
Usually the logs are winched in through the
upper pulley of the winch. This lifts the logs
and they dig less into the ground. The weight
of the load also pushes the blade into the
ground thus anchoring the winch and the
tractor to the ground.
•
The winch has a lower snatchblock. The main
use of the lower snatchblock is to lower the
pulling point. This enables larger loads to be
skidded out . For skidding out the load the
cable is transferred to the lower snatchblock.
•
Several logs can be hooked up and winched
in at one time by means of keyhole sliders on
the cable. The skidding chain should have a
pin on the end, which makes it easier to pass
!
CAUTION!
block and the lower snatchblock frame.
!
CAUTION!
18
When using the lower
snatch block make sure that
it follows the direction of the
cable. Otherwise the cable
will be damaged, when it is
pressed between the snatch
When wInching an unloaded
cable, make sure that the
with cable and doesn't
cause cable to crosscut.