Fastening The Cable To The Drum; Pre; Cable; Check That - Farmi Forest Corporation JL 601 Operating, Maintenance And Spare Parts Manual

www.normet.fi
JL 601
MOUNTING INSTRUCTIONS
4.4. FASTENING THE CABLE TO THE
DRUM
1. Tape the cable end to prevent loosening of
the core wires.
2. Pass the cable through the hole in cable
guard, over the upper snatch block and
then inside the winch.
3. Insert the cable from behind the roll of the
drum brake.
4. Pull the cable onto the drum from the left
hand side (the same side as the clutch
lever).
5. Pass the cable end through the hole in the
drum plate, pull about 15 cm (6"), and
insert under the wedge of the cable lock
device. See fig. 19.
6. Tighten the cable lock screw.
7. Winch the cable on the drum. BUT
REMEMBER THAT THE CABLE HAS TO
BE LOADED HEAVILY, WHEN
WINCHING THE CABLE BACK ON THE
DRUM.
Fig. 19.Fastening the cable.
Do not use longer cable than needed. With
correct length you achieve good pulling
strength and proper winding of the cable.
Normet Corporation
Ahmolantie 6
FIN --- 74510 PELTOSALMI
FINLAND
Tel. + 358 (0) 17 83 241
Fax. + 358 (0) 17 823 606
5. PRE- -OPERATION CHECKS

CABLE

Check that:

D The cable is faultless (breakage risk).
D There are no twists or kinks (breakage risk)
in the cable.
D the cable has been properly fastened to the

winch.

WINCH
Check that:
D All the pins and lynch pins are in place.
D All bolts and nuts have been tightened.
D Roller chain is tight.
D The drum brake has been properly
adjusted.
D The clutch has been correctly adjusted.
D Lubrication is carried out correctly. See
lubricating instructions.

MOUNTING TO THE TRACTOR

Check that:
D The tractor's top link point is locked. (with
the help of a support, if necessary).
D The pins are properly secured.
D The sway bars or turnbuckles are suitably
tight.
D The PTO--shaft is suitably long, properly
fastened and the shield chains attached.
D The support leg of the winch is turned
upward.
B // En // 141001MRu
Page 13