Pre-Operation Checks - Farmi Forest Corporation JL 351P Operation, Maintenance And Spare Parts Manual

FASTENING THE CABLE TO THE DRUM
1. Tape the cable end to prevent loosening of the
core wires.
2. Pass the cable through the hole in cable
guard, over the upper snatch block and then
inside the winch.
3. Insert the cable from behind the roll of the
drum brake.
4. Pull the cable onto the drum from the left hand
side (the same side as the clutch lever).
5. Pass the cable end through the hole in the
drum plate, pull about 15 cm (6"), and insert
under the wedge of the cable lock device. See
6. Tighten the cable lock screw.
7. Winch the cable on the drum. BUT REMEM-
BER THAT THE CABLE HAS TO BE LOADED
HEAVILY, WHEN WINCHING THE CABLE
BACK ON THE DRUM.
Do not use longer cable than needed. With
correct length you achieve good pulling strength
and proper winding of the cable.
JL 351P

PRE-OPERATION CHECKS

CABLE
Check that:
• the cable is faultless (breakage risk).
• there are no twists or kinks (breakage risk) in
the cable.
• the cable has been properly fastened to the
winch.
WINCH
Check that:
• all the pins and lynch pins are in place.
• all bolts and nuts have been tightened.
• roller chain is tight.
• the drum brake has been properly adjusted.
• the clutch has been correctly adjusted.
• lubrication is carried out correctly. See lubrica-
ting instructions.
MOUNTING TO THE TRACTOR
Check that:
• the tractor's top link point is locked. (with the
help of a support, if necessary).
• the pins are properly secured.
• the sway bars or turnbuckles are suitably tight.
• the PTO-shaft is suitably long, properly faste-
ned and the shield chains attached.
• the support leg of the winch is turned upward.
16