MAINTENANCE
SAFETY
Disengage the P.T.O and turn
the tractor off before you
!
service the winch, remove
the keys so the tractor cannot
be started up accidentally.
DANGER!
LUBRICATION
Do not oil the drive chain,
because the oil will work its
!
way to the clutch!
CAUTION!
The cable drum, main sprocket and snatchblock
Following points require lubrication:
1.
Grease the drum clutch parts after every 500
working hours. Always use good quality lubri-
cation grease.
2.
Grease the PTO-shaft regularly and aways
3.
Grease the drum chain lightly (not with oil)
after every 50 working hours with spray type,
hardening chain grease.
Wipe off the excessive grease.
Swing joints sideways for greasing
8h
When used in winter
the guard tubes must
be greased to avoid
freezing.
JL 351P
8h
20h
Apply grease inside the
h= working hours
CLUTCH ADJUSTMENT
1.
Loosen the nuts A and B at both ends of the
drum axle. Wrench opening 1 7/16" (36 mm).
2.
Adjust the clutch by turning the axle C with
9/16" or 14 mm wrench. The clutch tightens
clockwise, loosens counterclockwise. Turn
max. 1/4 turn.
3.
After adjustment retighten the nuts A and B on
the ends of the drum axle.
4.
Pull the control rope. The lever should move
up 1.5" (4 cm) before the clutch engages. If
the clutch engages earlier loosen the clutch
setting.
A
21
B C