SAFETY INSTRUCTIONS FOR WINCHES
•
Check that the wire cable is in good condition
before using the winch (check for corrosion,
sharp bends, breakage and thickness of
strands). If a cable snaps, it can whip towards
the operator or away from the winch.
•
Operate the winch with a guide cable at least 2
meters away to the side of the machine. Do not
operate the winch from the tractor cabin unless
a safety net has been installed.
•
When winching downhill, the pulling must be
done from the side using an additional idler.
•
When winching on a hill, do not follow the load
from below.
•
Side-winching must not be done at angles of
more than 30 degrees.
•
It is extremely dangerous to be in the space
between a load attached to the wire cable and
the winch.
•
Check that all bystanders are at a safe distance
of at least 15 meters whenever the machine is
running. Place warning signs on approaching
roads.
•
Never touch the wire cable by hand during
winching.
•
The maximum load must be adjusted to condi-
tions.
•
Check that the winching chains are carefully
attached. Do not attach the wire cable directly to
the load.
•
fasteners and 2 for chain-type fasteners.
•
Disconnect the transmission before examining
the machine in the case of any faults.
•
Ensure the wire cable is as short as possible
during transport.
•
The winch may only be used for winching and
hauling. Do not use the winch for lifting loads.
JL 351P
9