Mounting - Farmi Forest Corporation JL 351P Operation, Maintenance And Spare Parts Manual

MOUNTING

MOUNTING TO THE 3-POINT HITCH
The winch can be mounted to the 3-point linkage
of any tractor. Power transmission is obtained
through universal shaft from tractor.
ASSEMBLY OF THE PTO SHAFT
If the PTO shaft is too long
it may get pressed when the
!
three point hitch is lifted up.
This may cause damage to
the bearings of the winch
CAUTION!
or to the PTO of the tractor.
The PTO shaft must not be too short in any
position.
The PTO length is suitable, if the pipes do
not reach the bottom.
PTO is optional equipment.
1. Mount the winch to the 3-point hitch of the
tractor.
2. Raise the winch high enough to get the PTO
shaft of the tractor and the winch to a horizon-
tal level.
3. If you have a shortened PTO shaft available,
put one end into the drive shaft and check that
the distance of the locking of the other end.
Take into account the additional clearance of
approx. 20 mm (0.78").
4. Fasten the other end of the PTO shaft in its
place and also move the winch sideways at
the same time securing that the axis does not
base.
JL 351P
SHORTEN THE DRIVE SHAFT
!
CAUTION!
• First cut the thicker cover to a correct lenght
(1). Remember 20 mm (0.78") clearance.
Then cut away the same amount from the
form pipe. Make a similar shortening to the
second half of the PTO shaft. Remove the burr
• Connect the PTO shafts within each other.
Make sure by moving eevator carefully up and
cient. Check that the axis have 20 mm (0.78")
latitude.
15
Both PTO halves must
be shortened by equal
amounts.
A
20
A
1 2
-