Assembly Of The Mechanism - Farmi Forest Corporation JL 351P Operation, Maintenance And Spare Parts Manual

ASSEMBLY OF THE MECHANISM

Make sure that the both pressure bearings are
installed in a correct position, that is, the bearing
with bigger internal diameter should be facing
position of the two clutch engagement halves is
1. Place one of the clutch engagement halves
on the working tble so that the handle is at 8
o'clock position and the 3 slanted surfaces
face up.
2. Grease the 3 slanted surfaces with vaseline
and place the 3 rollers on the bottom of the
slanted surfaces so that the thin ends point
towards the middle. The other clutch enga-
gement half (without handle) has 3 slanted
surfaces on one side and two holes drilled on
on when the winch is assembled.
3. Place one clutch engagement half (without the
handle) so that the halves bottom out when
the handle is at 8 o'clock position and the two
Be careful, there is only one correct position!
Tape the halves together so that htey will stay
together when you mount them on the drum
axle.
Race with smaller inside diameter
Race with larger inside diameter
The race with the larger inside
diameter is towards the drum
JL 351P
halves
4. Install a protective plate. Check the clutch
adjustment.
Drum axle
23
12
8
6
12
6
12
8
6
Wire drum
The race with the larger inside
diameter is towards the drum
a)
b)
c)