Maintenance Instructions; Refilling Of Brake Fluid; Oil Tank Of Hydrostatic Steering; Front Output Shaft - Zetor Z 8641 Supplement Operators Manual

REFILLING OF BRAKE FLUID

The tank is accessible after removal of
the right rear bonnet side.
Keep the brake fluid level between 3/4 of
the tank capacity (max.) and 1/2 of the
tank capacity (min.).
When handling with brake fluid
pay special attention to clean-
ness. Check the brake fluid level
before each drive.

MAINTENANCE INSTRUCTIONS

D401
OIL TANK OF HYDROSTATIC
STEERING
The tank is accessible after removal of
the right rear bonnet side.
Using the oil-gauge rod (A) check level
of oil in the hydrostatic steering tank;
keep the level between the marks MIN.
and MAX., see Fig. (A).
After removing the nut (1) and tank lid re-
fill oil as necessary.
28
402

FRONT OUTPUT SHAFT

The oil check and refilling plug (1) is lo-
cated on face of the front output shaft
box.
In case of a front output shaft with stan-
dard direction of rotation the oil check
and refilling plug is replaced for a hollow
screw of the oil cooler hose. Perform
check after removal of the hollow screw.
After removing the check plug
the oil level shall reach the
check hole lower edge.
When replacing oil, clean the strainer oil
cleaner (2). It is accessible after removal
of the lock ring and lid.
F206