Icmp-Echo - Cisco Nexus 7000 Series Command Reference Manual

icmp-echo

icmp-echo
To configure a Cisco nx-OS IP Service Level Agreements (SLA) Internet Control Message Protocol
(ICMP) echo probe operation, use the icmp-echo command. To remove the settings, use the no form of
this command.
Syntax Description destination-ip-address
Command Default
None
Command Modes
IP SLA configuration mode (config-ip-sla)
Command History Release
6.2(2)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure an IP SLA Internet Control Message Protocol (ICMP) echo probe
operation:
switch# configure terminal
switch(config-ip-sla)# icmp-echo 10.3.3.2
switch(config-ip-sla)#
Related Commands Command
ip sla
ip sla responder udp
echo ipaddress
Cisco Nexus 7000 Series NX-OS IP Service Level Agreements (SLAs) Command Reference
1-16
icmp-echo destination-ip-address
Destination IPv4 address of the operation.
Modification
This command was introduced.
Description
Begins the configuration for an IP SLAs operation and enters IP SLA
configuration mode.
Permanently enables the IP SLAs responder functionality on a specified IP
address and port.
Chapter 1 Cisco Nexus 7000 Series IP SLAs Commands
OL-27555-03