Cisco Nexus 7000 Series Command Reference Manual page 33

Chapter 1 Cisco Nexus 7000 Series IP SLAs Commands
range
randow-frequency-range
life forever
seconds
start-time
hh:mm[:ss]
month
day
pending
now
after hh:mm:ss
Command Default
The multioperation schedule is placed in a pending state (that is, the group of IP SLAs operations are
enabled but are not actively collecting information).
Command Modes
Global configuration mode (config)
Command History Release
6.1(1)
OL-27555-03
(Optional) Enables the random scheduler option. See the "Usage
Guidelines" section for more information. The random scheduler option is
disabled by default.
The frequencies at which the IP SLAs operations within the multioperation
schedule restart are chosen randomly within the specified frequency range
(in seconds). Separate the lower and upper values of the frequency range
with a hyphen (for example, 80-100).
(Optional) Schedules the IP SLAs operations to run indefinitely.
(Optional) Number of seconds that the IP SLAs operations actively collect
information. The default is 3600 (one hour).
(Optional) Indicates the time at which the group of IP SLAs operations start
collecting information. If the start time is not specified, no information is
collected until the start time is configured or a trigger occurs that performs
a start time now.
(Optional) Absolute start time for the multioperation schedule using hours,
minutes, and (optionally) seconds. Use the 24-hour clock notation. For
example, start-time 01:02 means "start at 1:02 a.m.," and start-time
13:01:30 means "start at 1:01 p.m. and 30 seconds." The current day is
implied unless you specify a month and day.
(Optional) Name of the month in which to start the multioperation schedule.
If the month is not specified, the current month is used. Use of this argument
requires that a day be specified. You can specify the month by using either
the full English name or the first three letters of the month.
(Optional) Number of the day (in the range 1 to 31) on which to start the
multioperation schedule. If a day is not specified, the current day is used.
Use of this argument requires that a month be specified.
(Optional) Indicates that no information is being collected. This is the
default value.
(Optional) Indicates that the multioperation schedule should start
immediately.
(Optional) Indicates that the multioperation schedule should start hh hours,
mm minutes, and ss seconds after this command was entered.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS IP Service Level Agreements (SLAs) Command Reference
ip sla group schedule
1-23