Cisco Nexus 7000 Series Command Reference Manual page 14

fabric-path echo
fabric-path echo
To configure a Cisco NX-OS IP Service Level Agreement (SLA) FabricPath echo probe operation, use
the fabric-patch echo command in the IP SLA sub-configuration mode.
Syntax Description switch-id
profile profile-id
interface type number
Command Default
None.
Command Modes IP SLA sub-configuration (config-ip-sla)
Command History Release
7.2(0)D1(1)
Usage Guidelines
Before starting the operation, install and enable the fabricpath feature set on the device.
Examples This example shows how to configure operation 6 as a Cisco NX-OS IP SLA FabricPath operation:
switch# configure terminal
switch(config)# feature sla sender
switch(config)# ip sla 6
switch(config-ip-sla)# fabric-path echo 1 profile 10 interface ethernet 1/0
switch(config-ip-sla-fabric)# exit
Related Commands Command
show ip sla statistics
Cisco Nexus 7000 Series NX-OS IP Service Level Agreements (SLAs) Command Reference
1-4
fabric-path echo switch-id [profile profile-id [interface type number]]
Identity of the destination device.
(Optional) Specifies the profile on the device. profile-id can range from 1
to 65536.
(Optional) Specifies the interface used. If no interface is selected, the
default interface on the device is used.
Modification
This command was introduced.
Description
Displays the current operational status and statistics.
Chapter 1 Cisco Nexus 7000 Series IP SLAs Commands
OL-27555-03