Advanced Operations Using Alternative Power Sources; Using The House Current - Sony CCD-TRV75 Operating Instructions (primary manual) Operating Instructions Manual

Advanced operations
Using alternative power sources
You can choose any of the following power sources for your camcorder: battery pack,
house current, alkaline batteries (CCD-TRV75/TRV85/TRV93 only) and 12/24 V car
battery. Choose the appropriate power source depending on where you want to use
your camcorder.
Place
Indoors
Outdoors
In the car
Notes on power sources
•Disconnecting the power source or removing the battery pack during recording or
playback may damage the inserted tape.
•The DC IN jack has power source priority. This means that the battery pack cannot
supply any power if the power cord is connected to the DC IN jack, even when the
power cord is not plugged into a wall outlet.

Using the house current

(1) Open the DC IN jack cover, and connect the AC power adaptor to the DC IN
jack on the camcorder.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
1
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
connected to the wall outlet, even if the set itself has been turned off.
Note
Keep the AC power adaptor away from the camcorder if the picture is disturbed.
Power source
House current
Battery pack
Size AA (LR6)
Alkaline battery
12 V or 24 V car battery
Accessory to be used
Supplied AC power adaptor
Battery pack NP-F330 (supplied), NP-F530,
NP-F550, NP-F730, NP-F730H,
NP-F750, NP-F930, NP-F950
Supplied battery case (CCD-TRV75/TRV85/
TRV93 only)
Sony car battery charger DC-V515A
2, 3
25