Optimizing The Recording Condition - Sony CCD-TRV75 Operating Instructions (primary manual) Operating Instructions Manual

Optimizing the recording condition

Use this feature to check the tape condition before recording, so that you can get the
best possible picture (ORC).
(1) While the camcorder is in Standby mode, press MENU to display the menu.
(2) Turn the control dial to select Ò, then press the dial.
(3) Turn the control dial to select ORC TO SET, then press the dial.
"START/STOP KEY" flashes.
(4) Press START/STOP.
The camcorder takes about 5 to 10 seconds to check the tape condition and
then returns to Standby mode.
1
MENU
Each time you insert the cassette
Perform the above procedures.
Notes on the ORC function
•When you set ORC TO SET, the recording on the tape is erased for about 0.1 second so
that the camcorder can check the tape condition. Be careful when you use a recorded
tape. The 0.1 second blank is erased if you record from the point where you set ORC
TO SET for more than 2 seconds, or if you record over the blank.
•You cannot use this function on a tape with the red mark on the cassette exposed.
2
TAPE SET
REC MODE
ORC TO SET
REMAIN
3
TAPE SET
REC MODE
ORC TO SET
REMAIN
RETURN
4
START/STOP
TAPE SET
ORC
REC MODE SP
ORC TO SET
REMAIN
RETURN
START/STOP
KEY
STBY 0:00:00
51