Maintenance And Care; Preventative Maintenance - Dantherm CDF 40 Service Manual

Maintenance and care: Preventative maintenance

Preventative maintenance

Introduction
The dehumidifier requires very little attention for trouble free running. All the necessary
safety and control functions have been built in. The fan motor(s) and the compressor have
permanent lubrication and require no particular maintenance.
Injury - risk of cuts and minor skin burns, when you access the inside of the CDF
Warning
CAUTION
Be cautious of sharp edges when opening the unit. Internal parts can be very hot or cold.
•
Caution
•
Monthly service
The air inlet filter is to be cleaned once a month. The filter is placed in a stand behind the grill
of the air inlet duct. Drip tray and outlet should also be cleaned, so water can run off freely.
Please follow this procedure to perform the monthly service:
Step Action
1
2
3
4
NB: If the filter (one size PPI filter with order no. 094686) has to be replaced, you can order it
through a Dantherm dealer.
Annual service
The dehumidifier should be inspected once a year.
Please follow this procedure to perform the annual service:
Step Action
1
2
3
4

Maintenance and care

Switch off CDF for half an hour prior to opening it. Avoid touching very hot and cold
parts as e.g. the pipes or evaporator.
Avoid touching sharp edges or wear gloves.
Unlock the two locks underneath the dehumidifier
Dismount the front cap by lifting it up and take out the filter.
The filter is located on the rear of the front cap
Wash the filter in tepid soapy water or vacuum clean thoroughly.
If the filter is faulty, replace it.
Insert filter in the filter holder, reattach the cap and lock the two locks. (From Step 1)
Remove the front from the dehumidifier
Inspect the inside of the dehumidifier
Vacuum clean the dehumidifier to remove any dust or debris
Important: Vacuum clean the condenser thoroughly
If necessary wash the lamella evaporator in tepid soapy water if it is badly soiled
19