Table of Contents
Advertisement
Both installation procedures use the NCR CAM3 SCSI configura-
tion tool to load the SCSI device drivers into the operating system.
This utility is provided on the diskette with the NCR SDMS
drivers for SCO UNIX. The CAM3 main menu presents the
following options:
The CAM3 Main Menu Options
1. Configure the NCR SCSI Device Drivers
2. Add or Remove Specific Devices
3. Relink Unix
4. Remove All SCSI Devices
5. Show Current SCSI Configuration
Some of these options are referred to in the following procedures.
After completion of either installation procedure, CAM3 can be
invoked again from the UNIX prompt by typing:
mkdev cam3
In this way, CAM3 can be used to make subsequent changes in the
installation.
78
PCA-6157/6157L User's Manual
Allows
easy
Allows
easy
NCR installation tools for SCO UNIX
Installation
in the
Installation
on a
Advertisement
Table of Contents
