Os2Cam.add - Advantech PCA-6157 User Manual

Although the NCR SCSI controller's firmware can access the
SCSI hard disk drives attached to the computer independently, the
SCSI device driver OS2CAM.ADD acts as an enhanced interface
between the computer system and the SCSI BIOS firmware. Use
of the device driver increases the abilities of the SCSI controller
firmware and fully utilizes the advancements and improvements of
80386 and higher microprocessors.
The device driver is also necessary to support the use of SCSI tape
drives and CD-ROM drives with an OS/2 system. The NCR
OS2CAM.ADD device driver is written in compliance with the
IBM OS/2 ADD (Adapter Device Driver) specification and will
work with third party applications that complies with the same
specification.
Installing OS2CAM.ADD (with OS/2 already installed)
The NCR device driver floppy diskette contains two files, the
device driver OS2CAM.ADD and a text file, OS2CAM.DDP.
When the device driver installation utility under OS/2 is activated,
it looks for a file with the DDP extension. The DDP file contains
the necessary information to install the SCSI device driver.
1. At the OS/2 Desktop, double-click on System Setup.
2. Double-click on Device Driver Install.
3. Insert the floppy disk containing the NCR device driver in the
source drive, then click on the change button for the destination
directory.
4. Choose OS2 and click on the set button.
5. Click the install button.
6. Choose the NCR OS/2 2.X driver from the list provided by
clicking on it once. The choice will be highlighted. Click
the OK button, then the EXIT button.
68 PCA-6157/6157L User's Manual