Eclipse AH-MA Series Design Manual page 18

igure 3.5
wo-Stage Burner Profile Plates
6" Min.
2"
First
Stage
Burner
Profile
Plate
2"
X
Note:
Make all profile gaps equal (shown as "X" above); profile
plate width between the burners should be at least 3".
Duct Wall Air Flow
Steel channel of the correct width can be used as the center profile
plate. Install with the legs pointing toward the incoming air flow.
clipse AH-MA Air Heat Burner v2, Design Guide 160, 8/1/05
3" Min.
X X
Air Flow
Staged Burners
6" Min.
2"
Second
Stage
Burner
Profile
Plate
2"
X
6" Min.
Duct Wall