System Set-Up - Intec FORCE/2 HP Instruction Manual

Set up and Operation

System Set-Up:

Set system on a dry, level surface.
1. Obtain appropriate protective equipment.
a. Recommendations: dust mask, eye protection, gloves, knife to
cut insulation bags, and a hat.
2. Power Connections: Obtain two 12 gauge, heavy duty twist-lock
power cords (note: when requiring over 100 feet per power
cord, recommendation is to use 10 gauge in order to reduce the
voltage drop and allow for appropriate operation of motors).
Connect one power cord to the blower power inlet, and one to
the agitator & airlock power inlet. Note that each power source
is required to be an independent 15 amp (or greater) circuit.
T: 303-833-6644
Original Language - English
Blower and Agitator Power Inlets
800-666-1611
or
Instruction Manual
www.inteccorp.com
| 6