Intec FORCE/2 HP Instruction Manual page 12

toggle switch on the wired remote in the 'ON' position to start the agitator motor. Place
the agitator toggle switch in the 'OFF' position to stop the agitator motor.
b. If the rotary control switch is in the Wireless Remote setting, press the blower button on
the transmitter to start the blower motor. If the blower motor is running, press the
blower button on the transmitter to stop the blower motor. Press the agitator button on
the transmitter to start the agitator motor. If the agitator motor is running, press the
agitator button on the transmitter to stop the agitator motor.
Note 1: This system is designed for the blower to start first. The blower has to be on for
the agitator to be able to activate in both the Wired Remote and Wireless Remote
setting.
If activating system by the control panel, see System Set-Up '3c'. When placing the rotary control
switch in the Blower position only the blower motor will start. When placing the rotary control switch
in the Blower/Agitator motor, both the blower motor and the agitator motor will start.
3. Load Insulation -- Remove packaging and load
insulation.
Cellulose:
Set bag on edge of hopper & remove plastic wrapping.
Caution - Be sure no plastic goes into hopper.
Fiberglass or Stone Wool:
1.
Score bag in ½
T: 303-833-6644
Original Language - English
2. Bend bag to break in 1/2
800-666-1611
or
Instruction Manual
3. Place ½ bag on edge of hopper with open end
facing towards operator or away from operator
– do not have open end facing into the hopper.
Slice wrapper in direction shown to allow
product to expand into hopper.
Caution – Be sure no plastic goes into hopper.
www.inteccorp.com
| 11